Build a lot map before adding totals
A large cable lot becomes difficult to review when one total blends several specifications, reels, locations, and condition categories. Give every physical reel or continuous piece a stable line ID. Use it in the inventory, photo filenames, and any supporting record so a reviewer can trace exactly which evidence belongs to which material.
Tempe's Downtown Refresh covers the Mill Avenue streetscape from University Drive to Rio Salado Parkway. A seller may use that location as limited project or staging background, but it does not prove that a multi-reel lot exists or establish the identity, quantity, or release authority of any listed item.
- Stable reel or line ID
- Manufacturer, part number, and full designation
- Condition category attached to the individual line
- Photo and document filenames using the same ID
Preserve per-reel quantity and basis
Record reel count and continuous footage per reel or per piece. State whether each quantity is measured, documented, estimated, or unknown. Do not replace the individual values with a grand total, because several short lengths do not create one continuous length and estimates should not be presented as measurements.
If a line uses a weight, identify whether it is gross loaded-reel weight, cable weight, or another documented basis. Keep an estimated weight separate from footage and do not use it to supply an unsupported product identification.
- Reel count
- Per-reel continuous footage
- Measured, documented, estimated, or unknown quantity basis
- Condition category and stated weight basis
Keep site and release fields on the same row
For every line, record the actual storage location, the owner or controlling party, the release authority, known access restrictions, and available loading resources. Identical cable at two sites can still have different release contacts or physical constraints, so each site must stay visible in the lot record.
If permission is pending, mark the relevant line as pending rather than suggesting that one site’s authority applies to another. This page is about reconciling the records sellers already have; it does not assume a collection method, schedule, or agreement.
- Storage location
- Owner or controlling party
- Release authority or pending status
- Access restrictions and available loading resources
Make photos prove only the line they show
For each distinct reel or specification, provide a readable tag photo, jacket-marking photo, overall reel view, and any relevant visible-damage image. Tie the files to the line ID. One clean representative image should not stand in for reels with different labels, lengths, sites, or conditions.
Where the same product is represented by several reels, preserve the individual footage and location even if the product fields match. The photo set then supports a defined group without hiding a damaged reel, a partial reel, or a different release contact.
- Tag photo
- Jacket-marking photo
- Overall reel view
- Visible-damage note and condition category
Correct the blended-total mistake
The specific inventory mistake is a single grand-total footage number paired with one representative photo for a multi-site lot. The correction is one row per reel or continuous piece, with its specification, quantity basis, condition, location, release contact, and matched photo set. Unknowns should receive their own row rather than being folded into a total.
A fictional check record could list BL-T-01 as one documented 500-foot reel at Site A and BL-T-02 as one estimated 90-foot reel at Site B, with gross loaded-reel weight noted separately and authorization pending. For an actual list, email the organized inventory and photos to saleselectricalbuyers@gmail.com or call +1 (614) 715-3047.
- Use a row for every reel or continuous piece
- Keep site contacts and access details separate
- Label unknown or unmarked inventory explicitly
- Do not use one photo as proof for different lines
