Start with the manufacturer designation
A silvery conductor or a large cable diameter is not enough to classify an assembly as aluminum. Transcribe the manufacturer designation, part number, and explicit conductor-metal statement from the reel tag, jacket, or matching data sheet. If a matching record identifies tinned copper, mixed metal, or no metal at all, retain that status rather than relabeling the item by appearance.
Photographs should preserve the tag and visible legend, but the inventory line still needs a written field showing what the record supports. When the tag is incomplete, state which field is unconfirmed and keep that reel separate from a fully identified aluminum reel.
- Manufacturer and designation or part number
- Exact conductor-metal wording from the supporting record
- Tag and jacket-photo references tied to the same reel
Describe the entire feeder assembly
Record AWG or kcmil size, marked voltage, and any neutral, shield, drain wire, or messenger or support member exactly as documented. A feeder can include more than one material or member type. Do not carry an aluminum conclusion from a phase conductor into a neutral or support member without supporting evidence.
If the assembly configuration cannot be confirmed, list the visible designation and preserve the missing detail as unknown. This is more accurate than combining phase, neutral, shield, and support details into one broad aluminum label.
- Size and marked voltage
- Neutral, shield, drain, and support-member fields
- Separate metal statement for each documented assembly member
Report quantity, ends, and condition precisely
List each continuous remaining length and identify it as measured, documented, or estimated. State whether the reel is unused, factory-cut, or previously removed, and note exposed ends, reel condition, and visible jacket damage. Where footage is estimated, name the basis without converting the estimate into an exact figure.
Weight needs the same discipline. Label it gross, net, or unknown, and do not infer conductor content from a visible end. If only the reel condition is known, leave the weight basis unknown rather than supplying a guessed number.
- Continuous length with measured, documented, or estimated basis
- Condition history, exposed-end note, and reel condition
- Gross, net, or unknown weight basis
A fictional aluminum-feeder record
Illustrative inventory example—not a purchased lot: AL-HIA-04 lists an aluminum feeder designation from a reel tag at 4/0 AWG. The record shows 275 ft continuous, estimated, on a partial reel with an exposed end noted. Weight basis is unknown. The neutral or support-member field stays unknown until the matching tag or data sheet supports it.
This record avoids the common error of treating a silvery exposed end as proof of every conductor’s metal. The seller can add a clearer tag photo or matching product record later without revising an unsupported claim.
- Example reference: AL-HIA-04
- Known: 4/0 AWG and 275 ft estimated continuous length
- Unknown retained: weight basis and neutral or support detail
A permit reference is not a feeder specification
Miami-Dade describes an e-permitting application for contractors, engineers and planners and lists utility permitting among Public Works requirements.
That may help a seller explain the background for their own project record, but a permit does not identify a cable’s metal, size, voltage, or construction. Keep any project reference alongside—not in place of—the reel markings, quantity basis, condition, release authority, and storage-access facts.
- Project or permit reference only as context
- Seller-provided release authority
- Storage location and access restrictions
