Use a product record to identify aluminum
A silvery exposed surface is not enough to describe the whole feeder. Photograph and transcribe the manufacturer, part number, conductor-metal evidence, size and insulation designation from the tag or jacket. If a record identifies a particular element, attach that record to the same reel reference rather than applying it to nearby stock.
Do not substitute outside diameter, project role or a visual comparison for a product record. When the marking is unreadable, preserve the photo and list the metal evidence as unknown. That approach retains the useful evidence while avoiding a claim about an assembly that the record does not establish.
- Transcribe manufacturer, part number and metal evidence.
- Record AWG or kcmil and insulation as separate fields.
- Keep unreadable or missing markings on an unknown line.
Preserve every assembly element
A feeder can have components that need their own documentation. Keep the neutral, shield, support member and overall assembly configuration in separate fields. Do not assume that every element uses the same metal simply because one accessible conductor appears aluminum.
The common error is labeling the entire assembly from a single exposed surface. Resolve it with the tag, jacket legend and a matching product record. If those sources do not establish an element, leave that element unknown rather than silently extending the label across the assembly.
- Use separate fields for neutral, shield and support member.
- Match construction records to the reel reference.
- Do not infer an element from appearance.
Reconcile the current footage
A factory tag may show the original reel length, while the actual balance may be smaller. For each reel, record its ID, current continuous length, reel count and the basis for the figure. Use measured, documented or estimated as a visible status rather than treating all footage as equally certain.
When footage is estimated, note the evidence available, such as a remaining tag, inventory notation or an observed partial reel. Do not turn an estimate into a precise current balance. A buyer can then see both the number and the confidence level without guessing what was measured.
- Give each reel a stable reference.
- Record continuous length separately from original tag length.
- Label every figure measured, documented or estimated.
Describe condition and site handling facts
Record exposed or protected ends, reel condition, storage exposure and any observed loading limitation. These are inventory facts, not promises about handling. Keep them with the reel reference so an intact reel is not used as a stand-in for a reel with a damaged flange or incomplete history.
If storage history is incomplete, state the limit directly. The seller can still provide a usable record by separating known condition observations from unknown historical details and by identifying the role that controls release of the offered item.
- Note end condition and reel condition separately.
- State storage exposure only when known.
- Identify the release role and actual access limitations.
Honolulu context and a fictional feeder line
Honolulu’s Public Infrastructure Map identifies major infrastructure categories including rapid transit, arterial roads, water reservoirs, sewage facilities, solid-waste facilities and pump stations across Oʻahu planning areas.
That public map is context for careful project records, not evidence that a particular feeder came from one of those categories or is available for sale. A fictional example is AL-HNL-02: aluminum feeder designation from a reel tag, 4/0 AWG, one partial reel at 275 ft estimated, neutral construction unknown, exposed end noted and storage history incomplete. It is not an actual lot.
