Document the full feeder assembly
Capture the manufacturer designation, part number, conductor metal, insulation, and size in AWG or kcmil from a readable label or matching product record. Add any neutral, shield, or support member that the record actually describes. A feeder is not fully described when only the largest conductor or an exterior appearance is listed.
Use separate fields for the identification source and the assembly detail. That keeps the record clear about what the reel itself shows and what a matching document supports. If a data sheet does not match the designation, leave it out of the evidence for that reel.
- Manufacturer designation and part number
- Metal source, insulation, and AWG or kcmil size
- Neutral, shield, or support detail when supported
Treat appearance as incomplete evidence
A silvery exposed surface alone is not enough to complete the metal field for every part of an assembly. Use jacket printing, a reel tag, or a matching product document. If those sources are unavailable, write metal status unconfirmed and state what was inspected rather than upgrading a visual impression into a product specification.
The relevant mistake is assuming that a feeder label or surface appearance proves every conductor and assembly component is aluminum. The resolution is simple: preserve tinned copper, mixed construction, and unconfirmed details as such while keeping the readable evidence beside the line.
- Identification evidence photo or product-record reference
- Metal status: confirmed, mixed, or unconfirmed
- Uncertainty note for each unsupported assembly field
Record the amount left on the actual reel
Give each reel an ID and record whether its continuous length is measured, documented, estimated, or unknown. Include visible end condition, reel condition, and jacket wear without turning a description into a performance claim. A partial reel should not inherit the original full-reel footage merely because the tag is still attached.
If a reel has more than one piece or an exposed end, retain that physical fact in the condition note. It is better to describe a partial, estimated length accurately than to merge it into a neat but unsupported quantity.
- Reel ID and continuous length
- Measured, documented, estimated, or unknown quantity basis
- End condition and visible reel or jacket condition
Keep location and release facts with the feeder line
Add storage location, loading constraints, available handling information, release authority, and any known timetable. These seller-provided facts explain what still needs confirmation without presuming transport, payment, inspection, or acceptance terms. If ownership or authority is not established, make that a visible pending field.
When several feeder reels are stored at one location, do not use a single access note to mask different release contacts or loading limitations. Connect the reel ID to the location and authority record that governs it.
- Storage location and loading constraints
- Weight basis when one is known
- Release authority and timetable, or explicit pending status
Use local context without treating it as a lot record
The City of Flint Economic Development department lists site selection, small-business assistance, incentives, business attraction and retention, and investment opportunities among its business resources. The fact is limited commercial context only and does not establish that any aluminum cable is available in Flint.
Illustrative record only — not a purchased Flint lot: AL-FL-01; aluminum feeder designation from reel tag; 4/0 AWG; 275 ft continuous, estimated; partial reel with exposed end; neutral/support not documented. The last field remains unknown rather than being inferred from the visible conductor.
- Keep unconfirmed assembly fields visible
- Do not group mixed-metal assemblies under one assumed metal
- Send clear label photographs and inventory records to saleselectricalbuyers@gmail.com
