Start with the cable’s printed designation
Transcribe the full jacket legend or tag rather than calling every multi-conductor line “tray cable.” Record TC, TC-ER, PLTC, or another designation only when it is actually printed or supported by a matching record. Add manufacturer, part number, and marked voltage when legible, and tie those details to one reel or piece reference.
A tray location, a control panel, or a project drawing can be useful background, but it does not establish the construction of the cable now being offered. For an unreadable jacket, use “unknown” for the designation and retain photographs rather than borrowing a description from adjacent material.
- Full jacket legend or tag text
- Manufacturer, part number, and marked voltage when known
- Reel or piece reference on every line
Separate construction variants before totaling footage
Create different lines when conductor count, pair count, gauge, shielding, or jacket construction differs. Two outer jackets can look alike while the assemblies serve different identification needs. Keeping these fields visible prevents a seller from grouping distinct cable merely because it was stored in the same bay.
List continuous length beside the same physical reference, not only a combined footage total. If a shield cannot be identified, say so. An explicit unknown field is more reliable than deciding that a cable is unshielded because no shield description appears on a partial tag.
- Conductor count and pair count
- Gauge and shielding status
- One continuous length with its measurement basis
Document ends, history, and visible condition
For each reel or removed length, state whether it is uninstalled stock or material previously in service. Describe fitted ends, jacket damage, exposed areas, and known storage history. This is a condition record, not a claim that the cable is suitable for any particular electrical use.
Use photo names that match the inventory reference. A useful set shows readable printing, the reel or coil overview, accessible ends, and material-specific damage. Do not let one clean reel stand in for other reels with different markings or conditions.
- Uninstalled or removed status
- Fitted-end and visible-condition notes
- Photo references matching the inventory line
Use local project context only to organize records
The City lists development services covering permitting, plan review, inspections, development engineering and planning, and customer support. That information may explain why a development or facility closeout retains permit or project records, but it cannot prove a cable type, ownership, or available quantity.
Include the New Braunfels storage location, release authority, and access constraints after the construction fields. Keep the data sheet reference beside the specific line it supports. If a document does not match the part number or piece, describe the mismatch rather than using it as confirmation.
- Storage location and release authority
- Data-sheet reference matched to the line
- Unknown or mismatched document status
Model the line record without filling gaps
A fictional record could state: CT-NB-01; TC-ER marking; 12 conductors, 16 AWG; shielding unknown; 240 ft measured; removed cable with fitted ends. It is a fictional inventory example—not a purchased lot. It shows that an unknown shield field can remain visible while other details are still useful.
The typical error is treating every cable removed from a tray as Type TC and combining it under one length. The correction is to preserve printed designation and separate each conductor, pair, shield, length, and condition difference before sending the inquiry.
- Unknown fields retained as unknown
- Fictional example separated from real inventory
- No grouping until construction fields match
