Read the marking before naming the cable
Begin with the readable jacket legend and reel tag. Preserve a complete designation such as TC, TC-ER, or PLTC exactly as shown, along with manufacturer, part number, and marked voltage. A rack label, route name, or tray location may explain where material was stored, but it does not replace the product designation.
If the marking is incomplete, take a close photo of the readable portion and record the designation as unknown or partial. Do not copy a neighboring reel’s label onto an unreadable cable. That protects the line from an attractive but unsupported classification.
- Photograph the jacket legend and the reel tag.
- Transcribe the full printed designation where readable.
- Flag unreadable or conflicting designation as unknown.
Split assemblies by the fields that change
Make separate lines when conductor count, pair count, gauge, overall shield, individual shield, or jacket differs. A multi-conductor assembly may look similar beside another reel while serving a different documentation path. Retaining these fields makes the inventory specific without attempting to draw technical conclusions from appearance.
The recurring mistake is to call every cable found in a tray Type TC and add all footage together. The correction is simple: keep actual markings, conductor or pair counts, shielding, and each continuous piece on separate lines. If a field cannot be read, preserve it as unknown rather than normalizing the group.
- Keep conductor count and pair count as distinct fields.
- Record overall and individual shielding separately when documented.
- Split reels when gauge, jacket, or designation changes.
Retain continuous length and fitted-end facts
For each reference, state the continuous footage and whether it is measured, documented, or estimated. Do not add several cuts together and call the result one available length. Record fitted ends as present, absent, or unknown and pair the note with a photo when safe and available.
Length and end condition are inventory facts, not a statement about fitness for a particular use. If only an estimate is available, record the method and keep it separate from a documented reel balance. A clear limitation is more useful than a precise-looking assumption.
- Use one reference for each reel or continuous cut.
- State the footage basis beside the numerical length.
- Show fitted ends and visible differences in photo references.
Link photos to condition and source notes
Match tag, jacket, overview, and condition photos to the same inventory reference. Then state whether the line is uninstalled inventory, project overrun, or previously used cable, without collapsing these histories into one status. Record storage location and visible damage where known so the record explains the actual line, not an idealized representative reel.
When documentation is incomplete, describe the gap. For example, “shielding unknown; jacket photo CT-AA-04-2; length estimated by count” is a usable entry. It lets the inquiry retain the evidence that exists while avoiding a borrowed designation or a blanket condition claim.
- Use photo filenames that contain the inventory reference.
- State material history only as supported by the record.
- Record storage location and visible damage separately.
Use local project context without inferring cable type
The same University of Michigan project list shows Replace Secondary Electrical Distribution at Randall Harrison M Laboratory with construction scheduled from 05/11/2027 to 12/31/2027. A project or building reference can be retained with an Ann Arbor inventory file, but it does not establish a control-cable designation, availability, or buyer relationship.
Illustrative inventory example—not a purchased lot: CT-AA-04 reads “TC-ER marking; 12 conductors, 16 AWG; shielding unknown,” with “240 ft measured continuous” and “previously used cable; fitted ends present.” Photo references are matched, while release authority is unknown. This record remains specific without assuming a shield arrangement from the tray location.
- Keep a project reference as background, not the product specification.
- Match photo references to the unique cable line.
- Leave shielding and release authority unknown when unsupported.
